Fender Twin Amplifier Bedienungsanleitung PDF herunterladen (Seite 8)

A PRODUCT OF:

FENDER MUSICAL INSTRUMENTS CORP.,

CORONA, CA 91720

MADE IN U.S.A.

PART NUMBER: 120V version: 21-4809

230V version: 21-4889

TYPE: PR 266

DIMENSIONS: Height: 20-3/4” (52.7 cm)

Width: 26-3/8” (67 cm)

Depth: 11-1/2” (29.2 cm)

Weight: 77 lbs. (35 kg)

POWER REQUIREMENT: 120V version: 120 volts AC, 60 Hz, 360 watts.

230V version: 230 volts AC, 50 Hz, 360 watts.

FUSE TYPE: 100V and 120V versions: 4A SLO-BLO, 125V min.

230V and 240V versions: T2A, 250V.

INPUT IMPEDANCE: Input 1: 1M ohm.

Input 2: 136k ohm.

EFFECTS LOOP: Pre reverb.

Nominal level: +2, -5.5, -13 dBV.

Output impedance: 4.2k ohm maximum.

Input impedance: 130k ohm minimum.

EFFECTS MIX CONTROL: Continuously variable between the signal at

the EFFECTS SEND and EFFECTS RETURN jacks.

REVERB: Post effects loop.

PRE-AMP OUT: Post reverb, +1.3 dBV nominal level.

Recommended load: 22k ohm minimum.

POWER AMP IN: +1.3 dBV sensitivity, 130k ohm input impedance.

BALANCE LINE OUTPUT: Derived from the output transformer, fully balanced.

+3 dBV nominal level into 600 ohms or greater.

Pin 1 floating, pin 2 (+), pin 3 (-).

AMPLIFIER LOAD IMPEDANCE: Switch selectable for 4, 8, or 16 ohms.

POWER OUTPUT: OUTPUT HIGH setting: 100 watts RMS, 5% THD.

into 4, 8 or 16 ohms. OUTPUT LOW setting: 25 watts RMS, 5% THD.

SPEAKER COMPLEMENT: Two Fender P/N 026488 Special Design 12” 8 ohm

speakers wired in series.

Specifications

1 2 3 4 5 6 7 8

Keine Kommentare

Fender Twin Amplifier Bedienungsanleitung Seite 8